7
PEGS
The tent comes complete with general purpose pegs. These will be suitable for
many sites but there will be some instances where different pegs will be
necessary. Your dealer will stock a range of pegs suitable for different types of
ground. For maximum effectiveness, pegs should be driven into the ground at a
45°angle away from the pegging point.
RAIN
We make our tents as resistant to the weather as possible. Occasionally you
may find slight leakage. This is not a fault with the manufacturing process or
materials and can normally be rectified by spot treating the seam with seam
sealant (see below).
SEAMS
The main seams of this tent have been factory taped to help prevent leakage.
Depending upon your expectations, it may be necessary to treat the remaining
seams with a seam sealant. Seam sealant should also be applied to areas
where the taping is damaged or has peeled away through wear and tear. It can
also be applied to areas where a leak may have developed. Seam sealant is
available through your dealer.
SUITABILITY
This tent is designed for use in light to moderate weather. During very strong
winds or snowfall we recommend that you take your tent down. The tent is
designed for occasional use; it is not designed for static or commercial use.
UV DEGRADATION
Tent fabrics can be weakened by prolonged exposure to sunlight. Under normal
holiday use your tent will give long service but use for extended periods in strong
sunlight will soon cause deterioration. In those cases it would be wise to use a
site as shaded as possible. UV degradation is not covered under the warranty.
The warranty does not cover tents used on permanent sites, displays or for
commercial purposes.
CONDENSATION
Tents contain a high proportion of synthetic materials and under certain
conditions will be effected by condensation inside the tent. This should
not be confused with leaking. Condensation can be improved by ensuring
adequate ventilation. The tent comes with various ventilation ports that
can be opened and it may also help to keep a door open when the weather
allows. Condensation and its effects are not covered under the warranty.
SAFETY
DO NOT COOK IN THE TENT OR USE NAKED FLAMES. READ AND
UNDERSTAND THE FIRE PRECAUTIONS LABEL SEWN INTO THE INSIDE
OF THE TENT.
8
DEFLATION
To pack away the tent:
1. Close all doors and openings, including those on the inner tent/s.
2. Close all window blinds.
3. Un-peg the guy lines and tie them neatly to avoid future tangling.
4. Un-peg the intermediate pegging points but keep the four corners in place.
5. Open the valves on each pole. The tent will start to deflate. Wait until most
of the air has been expelled.
6. Un-peg the four corners.
7. Fold/roll the tent towards the deflation valves to expel more air and then roll
to fit in the carry bag.
8. Ensure that the tent is totally dry before storing in a cool, dry, dark space: if
possible opened out.
CARE
Tents are best stored opened out. Air fully and ensure it is totally dry before
packing away. Store in a well ventilated dry place. A wet/damp tent will develop
mildew surprisingly quickly.
Dirty tents can be washed using clean water and a soft brush. Do not scrub and
never use detergents.
The AirPoles do not need any maintenance but should be protected from dam-
age during storage. Damage due to improper use, wind damage or neglect is
not covered under the warranty. Have any damage repaired at the first oppor-
tunity.
Zips should be treated with care, use two hands to close and open and never
tread on them. Never force a zip. We strongly recommend that you carry a
comprehensive spares kit including silicone waterproof spray, seam sealer and
tape for repairing the AirPoles.
Repairs to the tent should be made by a company recommended by Kampa or
your supplying dealer. Repairs and alterations made by an unauthorised com-
pany may invalidate your warranty.
