5
Spread the flysheet on the ground
and locate the five black pole sleeves
on the roof.
Thread the fibreglass poles through
the outer sleeves.
One pole at a time, attach the pole
ends to the pins located on metal
rings at the base of the tent.
1
3
2
Stand the tent upright and pull into
shape. If necessary use the guy lines
to help hold the tent upright. We
recommend you start from the centre.
Once the tent is standing, thread the
front canopy pole through the tent
sleeve.
5
6
Repeat on the other poles whilst
doing step 5.
Fully tighten the tensioning straps at
each pole end.
4
6
Position the tent into the required
location.
Peg the four corners of the tent
ensuring good tension between them
to keep the flysheet taut.
Peg the intermediate pegging points.
Take the inner tent inside and
suspend from the colour coded
buckles. Attach the remaining
suspension points.
7
8
9
10
Attach the base of the inner to the
corresponding
buckles
on
the
groundsheet. It will be easier to
attach the rear points before fully
suspending the inner tent.
Guy the tent using the pre-attached
guy lines. Do not over tension as this
will exert unnecessary strain on the
tent.
11
12
