Position the Awning Mounting Brackets to align with
the spacing of the Angle Adjust Brackets. Tighten
fasteners lightly.
TOOL: 6 mm Hex wrench
Insert one 1 ⅝” into the bottom hole of each Angle Adjust
Bracket with the Crosswing lined up at the desired angle.
Tighten both 1 ⅝” bolts on each Angle Adjust Bracket.
If the Crosswing is not at the desired position: slightly loosen the four ⅝” bolts holding the
Crosswing to the Awning Mounting Brackets. Slide the Crosswing into the desired position
along the length of the vehicle.
With the help of an additional person, lift the
Crosswing up to the vehicle. Align the Awning
Mounting Brackets with the Angle Adjust Brackets,
slot the hook of each Awning Mounting Bracket onto
the bolts of the Angle Adjust Brackets, let the
Crosswing pivot down until it rests against the Angle
Adjust Bracket, the Crosswing will hang safely.
5
7
8
6
Crosswing Setup Instructions
Tighten all four ⅝” bolts holding the Crosswing to the
Awning Mounting Brackets.
Check that all fasteners are securely tightened.
9
10
Page 5
