6
7
Your Kambrook 8 Litre Urn
1.
Safety locking lid
2.
Cool touch carry handles
3.
Water window
4.
‘POWER’ light
5.
Variable temperature control
6.
Non-drip tap with two way
flow lever
Not Shown
•
1800 watt concealed element
•
Boil dry cut-out protection
•
Safety reset button
(under the base)
KUR10 Aquarius
8L Urn
KUR50 Express Cup
8L Stainless Urn
Operating Your Kambrook 8 Litre Urn
Before First Use
Remove any promotional and
packaging materials.
It is recommended that before the first
use, the urn is filled to the maximum
level, boiled and water discarded.
1.
Fully unwind power cord.
2.
Place the urn on a dry,
level surface.
3.
To fill with water, turn the locking
lid anti-clockwise and remove
(Fig.1).Use a small container to
fill the urn between the minimum
(3 litre) and the maximum (8 litre)
marks on the water window. Too
little water will result in the urn
switching off. Do not fill water
above the maximum 8 litre mark
water window as boiling water
may splash out from the urn.
Fig. 1
4.
After filling the urn, ensure that the
lid is replaced and locked firmly
into position with the steam holes
located on the rear side of the urn.
5.
Plug the power cord into a 230V or
240V power point and switch on.
6.
Turn the variable heat control to
‘5’ for fast boiling. The red ‘POWER’
light will illuminate.
7.
When the unit has boiled, select
the desired setting from ‘MIN’
to ‘4’ to maintain temperature
(Kambrook recommends setting
‘2’ or ‘3’ for tea or coffee).
NOTE:
Do not open the lid when
in operation as steam may
escape from top of the urn.
NOTE:
Steam may escape from
the steam holes on top of the
urn. Exercise caution at all times.
8.
To pour hot water, place a cup
below the non-drip tap and push
the tap down. For continuous
pouring, lift the tap up until it is in
the vertical position.
NOTE:
Use caution when
dispensing water from the urn, as
boiling water will scald. Do not
dispense the water too quickly.
9.
After use and before cleaning,
switch the appliance to
‘STAND BY’, switch the power
off at the power point and then
remove the plug.
NOTE:
The lid should always be
fitted and locked into position
when in use.
NOTE:
Always empty the
urn before moving to a new
position/location.
Summary of Contents for KUR10
Page 6: ...10 11 Notes Notes...
