Kambrook KCE95, Instruction Booklet

Page: 10 / 12

9
Setting the Oscillation
This function will work in any mode.
Pressing the SWING button will allow
the heater to oscillate back and forth.
To stop the unit oscillating, press the
SWING button once more.
Setting the Variable
Thermostat Temperature
1. Press the MODE button until the
heater is set to the AUTO mode.
2.
To adjust the set temperature,
rotate the Thermostat dial
clockwise to increase the desired
temperature and counter-
clockwise to decrease the desired
temperature.
3. The desired temperature can be
set between 15ºC and 38ºC.
4.
When the air temperature
reaches 2ºC above the set
temperature the heater will stop
heating at once and stop blowing
after approximately 15 seconds.
5. When the air temperature drops
1ºC below the set temperature
the unit will reactivate.
Safety Features
This heater includes an audible alarm
to warn that parts of the heater are
overheating. If this alarm sounds,
immediately turn the heater off
and inspect for any objects on or
adjacent to the heater that may
cause high temperature.
WARNING:
Do not
operate the heater with
the alarm sounding.
ThermoGuard Overheating
Safety Device
Your heater is fitted with a safety
device that switches off the heater
in the event of overheating. Should
this heater stop working, turn off the
heater and inspect the air inlet and
outlet for blockages. Wait until the
unit is fully cooled for the protection
system to reset before attempting to
restart the heater.
If the heater fails to operate or the
safety device switches off again,
return the heater to your nearest
service centre for examination
or repair.