Kambrook KCE240, Instruction Booklet

Page: 11 / 16

10
Setting the Oscillation
This function will work in any mode.
Pressing the ‘SWING’ button will allow
the heater to oscillate back and forth.
To stop the unit oscillating, press the
‘SWING’ button once more.
Setting the Auto-Off Timer
The timer function works in all
operating modes, and switches the
unit off after a preset number of hours.
• Press the ‘TIMER’ button to
activate the timer settings.
• Press the ‘TIMER’ button to cycle
through the one hour increments,
up to 8 hours.
• The heater will then switch itself to
standby mode after the selected
number of hours has passed.
Setting the Variable
Temperature
The variable temperature can be
used to maintain your desired
room temperature.
NOTE: The variable temperature
only operates when the heater
is being used in the auto mode.
1.
Press the ‘MODE’ button until the
heater is set to AUTO mode.
2. The LED screen will flash and display
the default 35°C temperature
setting for about 10 seconds to set
your desired room temperature.
3.
To adjust the temperature
settings, press the ‘TEMPERATURE’
(+) button to increase the
temperature and (-) to decrease
the temperature. The desired
temperature can be set between
15°C and 35°C.
4.
When the temperature shown
on the LED screen exceeds the
set temperature, the heater will
automatically cut out, and the
LED screen turns OFF, however
the fan may continue to run for
approximately 15 to 20 seconds
to cool the heater.
5.
When the air temperature drops
below the set temperature the
unit will begin heating again.
Using the Remote Control
Remove the plastic sheet between the
battery and the battery compartment
before using the remote control.
The remote control buttons operate
in the same way as those on the fan
control panel. Your remote control
includes 1 x CR2025 3V Lithium
battery, and can be conveniently
stored in the compartment on the
rear housing of the unit.
NOTE: Do not place the heater
close to other remote controlled
appliances. The infrared remote
control may trigger other
appliances.
Safety Tip-Over Cut-Out
Switch
There is a tip-over switch fitted to the
base of the heater, if the heater is
accidentally tipped over, the heater
will stop operating. Once placed back
into the upright position, the heater will
be in standby mode and the settings
will need to be selected again.
Using Your Kambrook Heater
continued