Kambrook Arctic HV KFA624, Instruction Booklet

Page: 8 / 12

7
Using Your Kambrook Arctic HV Floor Fan
Before First Use
Carefully remove the fan from its
packaging and also remove any
promotional material from the fan.
ImpoRtAnt:
When
unpacking the fan,
check to see you have
received all the items
before discarding
the packaging.
Assembling Your Kambrook
Arctic HV Floor Fan
To Assemble the Triangular Base
1.
The Triangular Base comes in
two pieces that first must be
screwed together.
2. Fit the smaller rounded end from
one side of the base into the
larger rounded end of the other
side of the base piece.
3. Once fitted together, align the
two pieces so that you can see
the screw hole clearly (Fig. 1).
Use the included small screw with
two washers to assemble the base.
Fit the thinner of the two washers
on to the screw first, followed by
the thicker washer and then, using
a screw driver, tighten into the
screw hole of the triangular base
until tight.
To Assemble the Fan Head
to the Base
4.
Carefully fit the attached
threaded screws located on both
sides of the pre-assembled Fan
Head into the holes provided at
each end of the Triangular Base
making sure that the point of the
Triangular Base is at the back of
the fan head (Fig. 2).
5. Fit a washer onto each screw
followed by the nut. Tighten the
nut with you fingers as much as
you are able.
6.
Fit a Tilt Adjustment Knob onto
each nut and use the knob
to tighten fully.
Fig. 1
Fig. 2