Kambrook Arctic HV KFA423, Instruction Booklet

Page: 9 / 12

8
NOTE: The Inner Extension Tube is
inside the Outer Extension Tube.
4.
Mount the pre-assembled Fan Head to
the Inner Extension Tube and tighten
the Fan Head Screw until it is tight (Fig. 5).
Fig. 5
IMPORTANT: The prongs
on the pre-assembled fan
head assembly may
need to be pried apart
slightly to more easily fit
on to the top of the
extension tube. Do not
force the pre-assembled
fan head onto the
extension tube.
5.
Press the two Tilt Adjustment Knobs
firmly on to the bolts located on
either side of the fan head. (Fig. 6)
Fig. 6
To Operate the Kambrook
Arctic HV Pedestal Fan
Plug the cord into a 230V or 240V power
point and switch on.
The fan has 3 speeds. To adjust the flow of
air, turn the fan speed dial located at the
back of the fan to the preferred speed -
LOW, MED or HIGH. To turn Off, turn the fan
speed dial to the OFF position.
NOTE:
To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit as your fan when it
is in use.
Adjusting Air Flow Direction
To adjust the flow of air left or right, manually
swivel the fan to the desired position.
To adjust the flow of air up or down,
slightly loosen the two tilt adjustment
knobs located on either side of the
fan and tilt the fan either upwards or
downwards to suit. Once the fan is in
the desired position, re-tighten the
two knobs to hold in place.
Adjustable Height
The fan height can be manually adjusted.
Simply loosen the Height Adjustment Knob
on the Extension Tube of the fan, then adjust
to the required height. Re-tighten the Height
Adjustment Knob when the desired height
has been reached (Fig. 6).
Fig. 6
Using Your Kambrook Pedestal Fan
continued-