4
5
Regularly inspect the power supply cord,
plug and actual appliance for any damage.
If found damaged in any way, immediately
cease use of the appliance and return unit
to the nearest authorised Kambrook
centre for examination, replacement
or repair.
OPERATING YOUR
KAMBROOK 8 LITRE URN
Remove any promotional and packaging
materials before use.
It is recommended that before the first
use, the urn is filled to the maximum level,
boiled and water discarded.
1. Fully unwind power cord.
2. Place the urn on a dry, level surface.
3.To fill with water, turn the locking lid
anti-clockwise and remove.
Use a small container to fill the urn. Do
not fill above the maximum 8 litre mark
on the external water window as boiling
water may splash out from the urn.
4. After filling the urn, ensure that the lid
is replaced and locked firmly into position.
5. Plug the power cord into a 230/240v
power outlet and switch on.
6.Turn the variable heat control to ‘5’ for
fast boiling.The red power ‘on’ light will
illuminate.
When the unit has boiled, select the
desired setting from ‘MIN” to ‘4’ to
maintain temperature (recommend setting
‘2’ or ‘3’ for tea or coffee).
To pour hot water, place a cup below the
non-drip tap and push the tap down. For
continuous pouring, lift the tap in the
vertical position.
After use, switch the appliance to ‘OFF’,
switch the power off at the power outlet
and then remove the plug when appliance
is not being used and before cleaning.
NOTE:The lid should always be fitted and locked
into position when in use.
Use caution when pouring water from the
urn, as boiling water will scald. Do not
pour the water too quickly.
Do not open the lid when in operation as
steam may escape from the top.
Steam may escape from the steam holes
on top of the urn. Exercise caution at all
times.
Always empty the urn before moving to a
new position/location.
Never carry the urn when in operation.
Always use the handles to carry the urn.
SAFETY BOIL DRY
PROTECTION
The urn is fitted with a safety device
which protects against overheating should
the appliance be operated with insufficient
water or has boiled dry. If this occurs, the
urn will stop heating.The red power ‘on’
light will turn off.
Switch the appliance to off, switch the
power off at the power outlet and allow
the urn to cool. Press the safety reset
button under the base before refilling the
urn.The safety device will then be reset
and the urn will be ready for use.
CARE AND CLEANING
Always switch the appliance to ‘OFF’,
switch the power off at the power outlet
and then remove the plug before cleaning.
Never immerse the urn controls or cord
in water, or allow moisture to come in
contact with these parts.
Removal of mineral deposits
Mineral deposits in tap water may cause
the urn element plate to discolour.This
may be removed by using a commercial
kettle descaler which is available from
most leading supermarkets, department
and hardware stores. Alternatively;
1. Fill the urn until 2/3 full with 1 part
vinegar and 2 parts water. Boil and allow
to stand overnight.
2. Empty the solution from the urn. Fill the
urn with clean water, bring to boil and
discard the water. Repeat and the urn will
be ready for use.
To clean the exterior
The outside of the urn may be wiped over
with a damp cloth and polished with a
soft, dry cloth.
NOTE: Do not use chemical, steel wool, or abrasive
cleaners to clean the urn.
