Kamado Joe ComboJoe CGJ26, Owner'S Manual

Page: 17 / 38

14
Leak Testing Procedure
1. Prepare a leak testing solution of sudsy water by mixing a solution of half
liquid soap and half water in a spray bottle.
2. Check and make sure all the control knobs are in the “OFF” position.
3. Turn cylinder valve knob counter clockwise one turn to open.
4. Apply leak-testing solution by spraying on joints of the gas delivery system.
5. Blowing bubbles in the soap solution indicates that a leak is present.
6. Stop a leak by tightening the loose joint or by replacing the faulty part with
a replacement part recommended by the manufacturer. Do not attempt to
repair the cylinder valve if it becomes damaged. The cylinder must
be replaced.
7. If you are unable to stop a leak, shut off the gas supply at the cylinder
valve. Remove the cylinder from the grill. Call an authorized gas appliance
service technician or LP gas dealer. Do not use the appliance until the leak
is corrected.
8. Push in and turn any control knob to release pressure in the hose and
manifold.
9. Turn off the control knob.
PRE-USE CHECKLIST
Leak Testing Procedure
DANGER
To prevent fire or explosion hazard, DO NOT smoke or allow any potential source of ignition
(sparks, electrical arcing, etc) in the area while performing a leak test. Leak test should be
conducted outdoors only. Never conduct a leak test using a fire or flame.
Perform a leak test at least once each year whether the gas supply cylinder has been
disconnected or not. In addition, anytime the gas cylinder is connected to the regulator or
any part of the gas system is disconnected or replaced, conduct a leak test. Use only a leak
testing solution as specified below.