5. BREAK-IN PERIOD AND TRIAL RUN
5.3
After break-in and trial-run course, replace the engine oil in the oil
sump.
Clean the engine oil filter and fuel filter. Check the tightening torques of the
cylinder head bolt and the others connecting bolts. These torques should meet the
requirement as specified.
5.1
A new engine needs a break-in period and a trial-run course. And this course
should not be less than 45 hours or 2800 km.
5.2
During the break-in period, don't let the engine stay at the high-speed state
with the fuel valve open fully. And you should increase the engine load slowly, at
the same time inspect the engine's running data measured by the all kinds of
meters.
[
]
OPERATION NOTICE
To make your engine run reliably and use for a long time, provide a new
engine with a break-in period.
During the break-in period, you should inspect all kinds of meters whether
work normally. After the break-in period, please replace the engine oil in the
oil sump.
6. THE STORAGE FOR A LONG TIME
[
]
OPERATION NOTICE
If you don't drain out the cooling reserved in the engine, it will be frozen,
which will damage the parts.
In order to reuse the engine normally, the following measurements should be
carried out when you store the engine for a long time.
(1) When stored for a long time in winter, the water in the engine should be
drained out. (If antifreeze is used, the water needn't be drained out). Drain out the
water by opening the draining water valve in the engine lower body. At the same
time, open the radiator cap to drain the water.
(2) Clean the dirt, dust and oil clinging to engine body.
(3) Periodically check and replace the engine oil.
(4) To prevent the fuel vapor changing into moisture in the fuel tank, you can drain
out the all of the fuel in the tank or refuel the fuel tank fully.
(5) Remove the negative terminal of the battery at the ground cable. In order to
makeup the wastage that caused by discharging of battery itself. Charge the
battery every month in the storage course.
(6) Add the lubricating oil to the acceleration coils and system.
(7) Coat the muffler, air cleaner, electric parts with the plastic cover to prevent the
water moisture and dust entering into those parts. The places in which the engine
stores should be dry and free of dust.
[
]
OPERATION NOTICE
When reuse the engine after storing for a long time, make the preparations
as using a new engine at first.
Summary of Contents for KM376AG
Page 1: ...THREE CYLINDER WATER COOLED DIESEL KM376 SERIES ...
Page 3: ......
