7. Maintenance
7.1 Replacing the saw
It is essential to wear protective gloves
when changing the blade.
Remove the corner plate (27) from the sliding
blade guide. (fig. 4)
Remove the protective guard (28). (fig. 5)
Turn the lever (29) towards the position “-”.
Remove the blade (30). (fig. 6)
Insert the new blade, taking care to observe the
cutting direction and placing it between the blade
guide rollers, then between the rubber pulleys
(31).
Turn the lever (29) towards the position “+”.
When the lever (29) reaches the end of its stroke,
the blade will automatically position itself for
cutting when the motor begins to turn.
Replace the guard (28) and the plate (27) of the
sliding blade guide.
During the first 4-6 cuts (after replacing
the blade) use light pressure, to increase
the duration and effectiveness of the
blade thereafter.
7.2 After Each Working Shift
Carefully clean all parts of the machine, to remove
shavings and cutting residue.
7.3 Periodically
Check the length of the electric motor brushes
and make sure they are efficient: if they are less
than 6 mm long, they must be replaced with
other identical ones.
The gear transmission requires no maintenance
since it runs on LONG LIFE lubricants.
8. Wiring Diagram
