Use the
Func
button to step through the modes options available and use the enter button to select and set the mode you require.
In each mode there is a sub menu or setting control that can be accessed via the
up
and
down
buttons to access the various
desired settings for each mode. To access the sub settings, you first press the
Func
button to access and set the mode you desire.
The LED display will flash and display the current mode, press the
Func
button again with one more press to step through the next
mode available. Use the function button to step forward through all modes. When you have sourced the desired mode press the
enter
button if you just want to select that mode without alteration of the sub menu and its settings. Then just press
enter
You will
see that the LED Display will show the mode you have selected and stop flashing if it is set.
To alter the settings of each mode, you will have to enter the sub menu. With the mode you have chosen displayed and flashing on
the LED display use the
up
and
down
buttons to access the various options or settings for that mode. Once you have reach your
desired setting then press the
enter
button to select and set it. In some operations again you use the
up
and
down
buttons to
increase or decrease the setting value. Once you reach your desired setting press
enter
. The display will flash and then return to
the mode, above the sub section you have just accessed.
Auto operation - Standalone pre-programed laser show
Press the
FUNC
button to enter
MODE OPTION.
Till to LED panel shows either one of Aut, Sou.
Press the UP or DOWN buttons to select your favourite standalone mode as above.
Press the ENTER button to confirm the setting. The laser is working in standalone.
In the MODE OPTION setting, the stand alone laser show that you are going to choose is flashing. Press UP or DOWN to change
stand alone laser show, you will have 2 different stand alone preprogrammed laser show.
*Their DISPLAY and EFFECT are listed in
TABLE 1
Sound-to-Light operation
Sound activated mode and sensitivity setting
Press
the
FUNC
button
till to see
S 0-9.
Press the
UP/DOWN
buttons to set microphone sensitivity. S 0 is no sound activated, and S 9 is maximum
sensitivity. From S 0 to S 9, the sensitivity level is going more sensitive.
Press the
ENTER
button to confirm and save the setting.
DMX operation
Press the
FUNC
button to enter MODE OPTION
Till to LED display shows
001
. Press the
ENTER
button
to confirm the setting.
The laser is now working in “DMX MODE”. Use the UP/DOWN buttons to change the DMX address.
There are 512 DMX channels to choose from and all units with the same address will operate via an external DMX controller at the
same time and in the same way. For individual control, each unit needs to be set with a unique address. The highest address this
unit can go to is 512
