KAM Par Kit WFS, Instruction Manual

Page: 5 / 9

Key to product diagrams
1. Par can 1
2. Par can 2
3. Par can 3
4. Par can 4
5. Controller
6. Wireless footswitch (WFS)
7. Sensitivity - used to adjust the mic’s input sensitivity during Sound-to-Light mode.
8. Microphone - used to monitor the music input during Sound-to-Light mode.
9. Par can connection sockets 1-4 (warning: do not unplug the par cans while the controller unit is powered on).
10. DMX input - 3 pin male XLR socket for DMX communication.
11. DMX output - 3 pin female XLR socket for DMX communication.
12. Mains power input IEC socket. Connect the supplied IEC cable to the input and the mains power.
13. Mains power output socket. Insert an IEC connection cable between this socket and a connected unit’s power input socket.
14. Controller retractable aerial - used to communicate with the wireless footswitch (WFS).
15. LED display - shows the various menus and the selected functions (see below table).
16. Function buttons x 4 – used to select the different menu items:
Menu button - choose the function you wish to adjust.
Up button - used to go up in the menu and to increase the values shown on the display.
Down button - used to go back in the menu and to lower the values shown on the display.
Enter button - used to confirm your choice.
17. Wireless footswitch retractable aerial - used to communicate with the controller.
18. Auto footswitch pedal.
19. Music footswitch pedal.
20. Colour footswitch pedal.
21. Blackout footswitch pedal.
Operation
The kit has five working modes:
•
Auto mode - built in programs not controlled by the wireless footswitch
•
Sound mode - automatic built-in programs - activated via Sound-to-Light
•
Manual mode - manual colour mix
•
DMX512 mode - DMX512 control via a controller
•
Master/Slave mode - unit is controlled by (or controls) other unit(s) in a master/slave chain
Wireless footswitch (WFS)
Ensure that a working battery is inserted into the underside compartment of the footswitch before operation. Wireless footswitch
operation is turned off during DMX and Master/Slave mode.
Pedal Function
Auto Press to activate the auto program controls. When working, all the lights will begin in auto mode.
Sound Press to activate the sound program controls. When working, all the lights will begin in sound mode.
Colour Press to activate the colour controls. R-G-RG-B-RB-GB-RGB.
Blackout Press and the unit will go into standby mode and turn all the lights off.