Press “FUNC” to exit this parameter. The value is stored automatically.
All values are stored and activated when you exit the parameter input b
y pressing “FUNC parameter. The
value is stored automatically.
Without changing anything in the parameter input routine, the panel will return to main routine after about
10 seconds without storing value to memory.
Note that playback of longer shows may be interrupted (stopped) when changing parameters at the panel
during show output. Display of single frames of short sequences normally will not be interrupted.
Limits
DMX base address 1
– 512
Intensity 0
– 99
Orientation 0
– 7
Limits will be controlled automatically by the panel. If trying to set a value beyond the limits, the panel
automatically corrects to an allowed value during input.
Intensity
The value under “Int” sets the maximum intensity for the laser.
All show values for RGB-outputs and analog intensity will be divided by this value linear.
For the projector, this value should be set to 99.
Orientation
There are 8 different values possible, allowing all possible projection orientations.
This is important for back projections or if it is not clear how the projector is installed at the location.
0: normal
1: X invert
2: Y invert
3: X and Y invert
4: X and Y changed
5: X and Y changed and X invert
6: X and Y changed and Y invert
7: X and Y changed and both inverted
Message center
If any error condition occurs, a code will be displayed on the status-LEDs (see table).
Not all errors will cause the stop of playback.
Errors from the memory card (read/write) will cause a total shutdown of the unit
If there is no card or the card is not inserted correctly of if the incorrect format or file system, the unit
functions will be shut down.
When there is no file allocated to a selected show number, this is no error condition and the unit will switch
the output to Pause (Shown number 0 PAUSE).
When the accessed show file is not valid or corrupted, the playback will be switched off.
All other functions keep running and the selection of another show is possible.
Ready
DMX
Data
Error
-
-
Yellow
-
No MMC/SD-card
-
-
Yellow
Red
File system FAT16 not found
Yellow
-
Yellow
Red
Data error when reading MMC/SD-card
Yellow
-
Yellow
-
File not found or invalid file
Yellow
-
-
X
No DMX-signal
Yellow
Green
-
-
Ready
DMX channels assignment
Channel1:
Show select L
This channel is used for show selection; one of the first 16 shows (including Pause) can be selected.
Channel2:
Show select H
16 banks of shows, 16 shows each, 256 shows can be selected using this function.
Channel3:
Size (projection size)
