Mounting :
Orientation:
This fixture should only be mounted/used on a flat surface. This fixture should not be tilted.
Rigging:
It is important never to obstruct the vents’ pathways. Mount the fixture using, a suitable “C” or “O” type clamp.
When selecting installation location, take into consideration the fluid reservoir access and routine maintenance.
Safety cables must always be used, utilising the provided safety eye bolt.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
General maintenance
To maintain optimum performance and minimise wear, the item should be cleaned frequently. Usage and environment are
contributing factors in determining the cleaning frequency. As a general rule, fixtures should be cleaned after use to avoid dust build-
up and blockages, which can result in poor performance, overheating and breakages. Be sure to uplug the unit from the mains
before
conducting any maintenance. Use a vacuum and a soft brush to remove dust collected on external vents and internal
components. Clean the external case when the unit has
completely
cooled down with a dry cloth or tissue.
Regular maintenance
Be sure to power off fixture
before
conducting any maintenance. Every 40 hours of continuous operation, it is recommended to run a
cleaning solution
composed of 80%
distilled
water and 20% distilled
white vinegar
through the system to prevent the
accumulation of particulate matter in the heating element.
The recommended cleaning regime is as follows:
1. Empty all haze/smoke fluid from the machine.
2. Add the above
cleaning solution
to the tank (80%
distilled
water and 20% distilled
white vinegar
).
3. Plug the unit in to the mains and allow it to warm up.
4. Run the unit in a well-ventilated area until the tank is almost empty.
Do not allow the pump to run dry.
Cleaning is now complete. Refill with haze/smoke fluid. Run the unit briefly to clear any cleaning solution from the system.
Trouble shooting
Symptom
Solution
No Power
Check mains power.
Check external fuse.
Check internal fuse.
No smoke output
Check fluid level.
Check remote.
If using wireless, check batteries.
Breaker/fuse keeps blowing
Possible electrical short. Contact retailer/distributor for further instructions.
Low smoke output
Run a cleaning solution through the smoke machine.
Check that the smoke machine is plugged into the correct voltage.
Smoke machine is not heating up
Check the external fuse / check the internal fuse.
Possible faulty part. Contact your retailer/distributor for further instructions.
Remote does not work
Make sure connector is firmly connected to device.
Possible faulty controller / try using another controller.
Check the external fuse / check the internal fuse.
LED fluid indicator states no
smoke but the container if full
Try resetting the smoke machine by turning the power off and then on again.
Possible faulty part. Contact retailer/distributor for further instructions.
Features & spec
Model
Kam KSM1100 V2
Power supply
230V AC - 50Hz
Power
900w
Fuse
F5A
Re-heat time
3 minutes
LED FX
3 x red LED
Output
10,000 CuFt per minute
Continue output
Yes
Tank Capacity
0.8 litres
Timer remote
Yes
Wireless remote
Yes
Gross weight
4Kg
