Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
9
SIS 40716 - 120501
Assembly page 9/40
Fax +1 305 430 9692
steam rate (“MAX”) can only be used when the ironing
temperature is set on the highest position (
) or else water
may drip from the soleplate.
•
While ironing, the iron’s pilot light (6) will go on and off from time to
time. This means that the temperature of the iron is being
regulated by the thermostat. You may continue ironing as it
adjusts itself.
•
When you use a lot of steam in a very short time, the steam output
is slightly reduced until your appliance produces enough steam to
maximize output. This phenomenon also happens when there is
not enough water in the water tank.
•
When the water tank is running empty, you will hear more noise
when pressing the steam button. When the water tank is empty,
the refill indicator (8) will light up. If you want to continue using the
steam function, you must refill the water tank. The water refill
indicator will go out once the water tank has been filled.
Note: when you start using the steam function, it is normal for the
electrical pump to make vibrating sounds. This is due to the air inside
the anti-lime scale cartridge and will lessen when the air has been
pumped out. If the noise has not lessened after 60 seconds, check to
see if the cartridge has been assembled correctly.
VERTICAL IRONING
The “burst of steam” button also allows you to iron delicate articles of
clothing vertically. To use the "vertical burst of steam" feature, first
hang your article of clothing on a hanger. Keep the steam button (4)
pressed or locked with the sliding trigger lock and move the iron
back and forth in front of the article of clothing. Make sure that the
soleplate does not come into contact with the fabric! The amount of
steam required and the distance between the soleplate and the
article of clothing depends of the kind of fabric and the depth of the
wrinkles.
WHEN YOU HAVE FINISHED IRONING
•
Turn the temperature dial on the iron to "
MIN
", switch the iron (11)
and the steam generator (9) off, and unplug the iron from the
electrical outlet.
