Install the Undercounter Lavatory (cont.)
Apply a continuous bead of quality silicone sealant to the top
surface of the lavatory rim where it will contact the countertop.
For Marble/Stone Countertops:
Install the lavatory to the
countertop with the clamps and anchor screws provided.
For Other Countertop Materials:
Refer to the countertop
manufacturer’s instructions for recommended fasteners.
IMPORTANT! Risk of product damage.
Overtightening the nuts
may cause irreparable damage to the lavatory.
Position the lavatory squarely under the cutout before tightening
the clamps. Draw the lavatory rim up against the countertop until
it is snug.
Do not overtighten.
Immediately wipe away any excess sealant and fill any voids as
needed.
Allow the sealant to set for 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Kallista
5
116108-2-D
