INSTALLATION INSTRUCTIONS
Whirlpool and Bath Undermount Kit
1096757_2_B
Page 3 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PRePARe THe COUNTeR
1.
Masking
Tape
Bath
Opening
Counter
Template
Flush Mount
Cut along template
inner cut line for
this installation.
Flush
Recommended
Edge
Counter
Counter
Bath Rim
Bath Rim
Recess Mount
Offset
Counter
Cut along template
outer cut line for
this installation.
Bath Rim
With the edges of the template parallel with the edges of the counter, affix the template to the counter using
masking tape.
NOTe:
A counter with radius edges is recommended.
Determine the preferred edge treatment for the counter. Consult with your local counter fabricator for
instructions on cutting the counter edges properly.
NOTe:
Some templates only have one cutout line.
Determine which cutout line you will using. If the edge of the counter will be flush with the edge of the bath
rim, you must cut the inner line. If the edge of the counter will be recessed from the edge of the bath rim,
you must cut the outer line.
Using the proper cutting method for your counter type, cut along the chosen edge of the template cutout
line.
Remove the template when cutting is complete.
Smooth the edge of the counter as needed.
Carefully position the counter on top of the bath to ensure correct fit and appearance. Adjust as necessary.
CAUTION: Risk of property damage.
Braces must be installed to support the weight of the counter from
below. Do not rely on the bath alone to support this weight. Refer to any instructions supplied with the
counter for proper bracing installation. If braces are not installed, the counter may flex and possibly
damage the bath.
Using 2x4s or other bracing material, add braces (required) to the underside of the counter.
