INSTALLATION INSTRUCTIONS
Deck-Mounted Bath Set
1149468_2_B
4 of 5
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALL The SPOUT
4.
Sleeve
Spout
Apply silicone sealant.
Setscrew
Plug
Remove the setscrew from the back of the spout assembly.
Apply a bead of silicone sealant to the underside of the base of the
spout according to the manufacturer’s instructions.
Position the spout on the sleeve, and carefully press down until the
spout contacts the finished deck.
Align the spout as desired and tighten the setscrew.
Install the plug into the setscrew.
Wipe away any excess silicone sealant with a damp cloth.
INSTALL The hANdLeS
5.
Handle Assembly
Screw
Sleeve
Stem Extension
Apply silicone sealant.
NOTe:
The hardware pack contains two different length stem
extensions and screws. Choose the stem extension and screw
combination that works for your installation.
Make sure the valves are closed (cold = fully counterclockwise;
hot = fully clockwise).
Install a stem extension on one of the valve stems.
Remove the sleeve from a handle assembly.
With the handle oriented correctly, place a handle assembly over
the stem extension and verify correct handle alignment.
NOTe:
The handle alignment can be adjusted by removing the
handle assembly and stem extension. Rotate the stem extension
one tooth and replace. Replace the handle assembly and check
the alignment. Repeat this procedure until the handle alignment is
satisfactory.
Remove the handle assembly and secure the stem extension to
the valve with the screw.
Re-install the sleeve into the handle assembly.
Apply a bead of silicone sealant to the underside of the base
of the handle assembly according to the manufacturer’s
instructions.
With the handle oriented correctly, hold the handle with one
hand and thread the handle assembly into the valve assembly
with the other hand.
