INSTALLATION INSTRUCTIONS
Kallista Bath Flip Drain
1117993_2_A
Page 5 of 7
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
FIT THe wASTe ANd OveRFLOw TO THe TUB
Lower Drain Gasket
Upper Drain Gasket
Drain Trim
Drain Outlet
Drain Elbow
Overflow Elbow
Overflow Outlet
Backplate
Bolt
Place the lower drain gasket on top of the drain elbow.
Set the upper drain gasket on top of the drain outlet.
Insert the drain trim through the drain outlet and thread into the drain elbow.
Hand tighten the drain trim into the drain elbow. Do not wrench tighten at this time.
Align the overflow elbow to the outside of the overflow outlet.
Insert the bolt through the backplate.
Insert the bolt with the backplate onto the threaded cylinder of the overflow elbow.
Turn the bolt clockwise until hand-tight to secure the bolt with the backplate to the threaded cylinder. Do not
wrench tighten at this time.
Verify the drain’s fit to the tub. Adjust as necessary.
Secure the Connections and Fittings
Wrench tighten the compression fittings to one quarter turn past hand-tight.
If using soldered connections, solder all joints at the tee.
Remove Waste and Overflow from Tub
Remove the drain trim, upper drain gasket and lower drain gasket from the drain elbow.
Remove the bolt and backplate from the overflow elbow.
Remove the drain assembly from the tub and loosely install tailpiece into the P-trap.
