INSTALLATION INSTRUCTIONS
Kallista Bath Flip Drain
1117993_2_A
Page 4 of 7
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INITIAL ASSemBLY
Drain
Elbow
Compression
Seals
Tee
Coupling Nut
Compression Ring
Compression Seal
Overflow Elbow
Overflow Pipe
Drain Pipe
Tailpiece
Compression Ring
Coupling Nut
Compression Ring
Coupling Nut
If using tee with compression joints:
Remove the overflow body, waste body, tailpiece and tee from the
packaging.
Disassemble the coupling nuts, compression rings, and compression
seals from the tee.
Assemble the drain elbow, drain pipe, tee, tailpiece, overflow pipe and
overflow elbow. Test fit the assembly to the bathtub.
If necessary, mark and cut the drain pipe and overflow pipe, using the
dimensions in the rough-in diagram and the rough-in information for
the tub as a guide.
Remove any sharp edges and retest fit to bathtub.
Disassemble the drain elbow, drain pipe, tee, tailpiece, overflow pipe
and overflow elbow.
Slide a coupling nut, compression ring, and compression seal onto the
overflow pipe. Repeat this process on the drain pipe and tailpiece.
Fit the overflow pipe, tailpiece, and drain pipe into the tee.
Hand tighten the coupling nuts onto the tee allowing movement of the
overflow body, drain body, and tailpiece.
Do not fully tighten the coupling nuts until instructed to do so.
If using tee with soldered joints:
Drain Elbow
Tee
Overflow Elbow
Overflow Pipe
Drain Pipe
Tailpiece
Assemble the drain elbow, drain pipe, tee, tailpiece, overflow pipe and
overflow elbow. Test fit the assembly to the bathtub.
If necessary, mark and cut the drain pipe and overflow pipe, using the
dimensions in the rough-in diagram and the rough-in information for
the tub as a guide.
Remove any sharp edges and retest fit to bathtub.
Do not solder the joints until instructed to do so.
