INSTALLATION INSTRUCTIONS
Cable Drain & Cable Drain Trim Kit
1096756_2_A
4 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INITIAL ASSemBLY
2.
Drain
Elbow
Compression Seal
Compression Ring
Coupling Nut
Tee
Coupling Nut
Compression Ring
Compression Seal
Overflow Elbow
Overflow Pipe
Drain Pipe
Tailpiece
Coupling Nut
Compression Ring
Compression Seal
If using tee with compression joints:
Remove the overflow body, waste body, tailpiece and tee
from the packaging.
Disassemble the coupling nuts, compression rings, and
compression seals from the tee.
Assemble the drain elbow, drain pipe, tee, tailpiece, over-
flow pipe and overflow elbow. Test fit the assembly to the
bathtub.
If necessary, mark and cut the drain pipe and overflow
pipe, using the dimensions in the rough-in diagram and the
rough-in information for the tub as a guide.
Remove any sharp edges and retest fit to bathtub.
Disassemble the drain elbow, drain pipe, tee, tailpiece,
overflow pipe and overflow elbow.
Slide a coupling nut, compression ring, and compression
seal onto the overflow pipe. Repeat this process on the
drain pipe and tailpiece.
Fit the overflow pipe, tailpiece, and drain pipe into the tee.
Hand tighten the coupling nuts onto the tee allowing move-
ment of the overflow body, drain body, and tailpiece.
Do not fully tighten the coupling nuts until instructed to do
so.
If using tee with soldered joints:
Drain
Elbow
Tee
Overflow Elbow
Overflow Pipe
Drain Pipe
Tailpiece
Assemble the drain elbow, drain pipe, tee, tailpiece, overflow pipe and
overflow elbow. Test fit the assembly to the bathtub.
If necessary, mark and cut the drain pipe and overflow pipe, using the
dimensions in the rough-in diagram and the rough-in information for
the tub as a guide.
Remove any sharp edges and retest fit to bathtub.
Do not solder the joints until instructed to do so.
