8. Install the Strainer Body
Lift the lever until it stops.
Insert the drain toggle assembly into the drain ell
The drain stopper should rise approximately 3/8
″
(1 cm) above
the strainer. Adjust if needed.
If adjustment is required, remove the drain toggle assembly from
the drain ell.
Raise the drain stopper by turning it counter clockwise, or lower
by turning it clockwise.
Tighten the nut until it contacts the underside of the drain
stopper.
NOTE:
If sufficient clearance cannot be obtained by adjusting the
drain stopper, remove the drain toggle assembly and then the lift
rod assembly.
Loosen the screw and slide the adjusting block up or down as
needed.
Tighten the screw and insert the lift rod assembly into the
overflow ell.
Insert the drain toggle assembly into the drain ell.
Recheck clearance.
Drain
Stopper
Nut
Threaded
Rod
Drain
Toggle
Assembly
Lift Rod
Assembly
Screw
Adjusting
Block
Adjusting
Rail
Kallista
11
1040187-2-A
