Kalley K-LED20HDT2, Service Manual

Page: 14 / 36

ITEM Defau Description Status
lt
Setti
ng
SW NO Software Version OK
DATE Date and time of software releasing OK
Project Name Module name OK
SIACP VERSION SIACP VERSION OK
Chassis MS306 Chassis name OK
PANEL NAME P/N of panel OK
NG
PROJECT ID >>> Select panel ID Number OK
CONFIG >>> Project Select submenu
USB UPDATE >>> USB UPDATE ok
HOTEL ENABLE HOTEL MENU SWITCH NOT
OFF USE
ReloadEFBItem Do Only for factory adjust OK
CONFIG submenu
ITEM Default Description Status
Setting
Erase HDCP Key Do Only for R&D OK
Reset HDCP Key Do Only for R&D OK
UsbHdcpkey Do Only for R&D OK
Update
USBPortNumset 1
USB port number set (1 or 2)
OK
5. Debugging
5.1. General Steps of debugging
According to the requirement of the order, below steps are needed
for appropriate setting.
1) Enter the Factory Menu, enable FAC HOTKEY.
2) Check Project ID and the version of software, release date
displayed at the bottom of Factory Menu.
3) Enter Design Menu, choose SERVICE MENU->Project ID, choose
corresponding Project ID number of the product (Refer to the
“V6
-PROJECT -
ID0**”in the BOM list).