KAKADU BIRDSVILLE, Owner'S Manual

Page: 5 / 12

5
™
USING YOUR LADDER
Do not use the ladder before reading the
below points. For your own safety and to avoid
any potential injury, ensure that the ladder
placement and angle is correct. Review the
below diagrams showing the correct angle
to position the ladder. Failure to do this may
result in injury. To achieve the correct angle,
you may need to adjust the ladder’s length. If
this is required, the adjustment must be done
from the top of the ladder. Ensure the ladder
is fully extended and all rungs are locked into
place. Once this is done, press the first set of
locking buttons positioned second rung from
the top. The ladder will then compress until
a gap of approximately 1/2 inch - 3/4 inch is
achieved between rung 1 and rung 2. If further
shortening is required, press the second set
of locking buttons which is positioned on the
third rung of the ladder. This will then close
the previous gap between rung 1 and rung
2. Swing in the bottom of the ladder until the
desired angle is reached. Review the below
diagram before using the ladder.
The ladder also acts as extra support and a
brace for the rooftop tent when in use.
Please note: Review the measurement
between where the ladder will sit on your car
and the ground before use. If this exceeds 7ft
2.6 inches then you may need to purchase an
aftermaket ladder to reach this length.
*Ladder needs to be removed when car is in
transit.
*Note, images are for illustrative purposes only.
*Note, images are for illustrative purposes only.