Operation Manual
SBG-30
Model SBG-30
- 4 -
(2) the dies components C #23,#24 for
the bending smaller shape,
(3) the dies components B #21,#22 for
the bending middle shape between the (1)
and (2).
2. Fixed the workpiece into the dies A1#8
(or B2 # 22 or B2#24) by the hex screws.
And press the workpiece tightly by the
small sliding wheel of the sliding plate
#20, to move the handle #15 to run the
rotary body, at the meanwhile to turn the
handle wheel for guarantee the sliding
wheel always pressed the workpiece
tightly. Thus the workpiece will be bend to
the shape same as the dies’
3.To turn back the sliding components
#20 and to loose the bolts which fixed the
workpiece, then the workpiece can be
taken out.
Lubricating:
( lubrication for every half year to one
year)
1.The lubrication part between the rotary
body #2 and the base #1: Please follow
the steps :to loose the bolts #10, take out
the dies, the bolts will be appear out and
then loose the bolts #6, turn the handle
wheel
#17
to
make
the
sliding
components #20 leave away the Die
Mounting Disc #3. Take out the Die
Mounting Disc and add some lubrication
grease, then install them step by step and
to keep them in a good working condition.
2. The
lubrication
part
between
the
sliding components and the screw shaft :
loose the screw #14, take out the press
plate #13, turn the handle to add the
lubrication grease to the shaft and sliding
components slots, then install them step
by step and to keep them in a good
working condition.
