kaivac
cleaning
systems
TM
P a g e ǀ
1 3
kaivac
cleaning
systems
TM
www.kaivac.com
©2020 Kaivac, Inc. All Rights Reserved
P a g e ǀ
1 3
3.1 f
iLLing
t
he
U
nit
3.0 Operation
There are multiple Fill Ports available to fill the Bucket with a hose or other source. The Fill Port at the rear of
the Trolley-Bucket is most convenient to access when using Chemical packets or Jugs.
Note the location of the Sight Gauge on the back of the Trolley-Bucket.
The Trolley-Bucket has a label with graduated markings. Gallon markings are displayed for 5 to 9 gallons.
For lesser quantity needs, the bottom of the label represents 4 gallons. For higher volume needs, the top of
the label represents 10 gallons. Filling over 10 gallons is not recommended.
Fill the tank with Kaivac or Kaivac approved Chemicals. Follow the proper
dilution instructions on bottles or dispenser. For accuracy and conve-
nience, use Kaivac proportioned chemical packets. Do not add chemical
to Trolley-Bucket if using Pump Box set-up.
TIP: I
F A CHEMICAL IS BEING USED, USE ONLY THE RECOMMENDED DILUTION.
CAUTION:
Before filling with solution, ensure the spigot is in the
“OFF” position.
Filling
Trolley
Fill Port
Fill Port
3.2 e
Mptying
v
ACUUM
t
Ank
If the Vacuum Motor shuts off before the job is complete, the Vacuum Tank may be full and need to be
emptied. Lift the Vacuum Motor to check liquid level inside the Vacuum Tank. If unit is full or your job is
complete, follow the instructions below to empty Tank into appropriate sink/drain.
Once cap is removed, lower Dump Hose
into appropriate sink/drain. To prevent
an accidental spill or overflow from the
Dump Hose, be careful to keep hose end
upright until it is over sink/drain.
To begin the dumping process,
you must first press down on the
Cap and turn counter-clockwise
PRESS
DOWN
TURN
Summary of Contents for Autovac
Page 2: ...kaivac cleaning systems TM ...
Page 24: ......
