Kaiser Baas GAMMA, User Manual

Page: 13 / 31

EN
GAMMA DRONE | User Guide
13
BATTERY CHARGING
To charge the Drone Battery:
1.
Remove the battery from the Drone by pressing the clip and sliding it out of the Drone
battery compartment.
2.
Connect the USB Charging Cable to the Battery Pin terminal located on the battery.
3.
Connect the USB Charging Cable to an electronic device.
Note: If using a wall charger, ensure that it is a certified product for your region.
AC Input: 100-240VAC 50/60Hz. DC Output: 5VDC 0.5A/1A/2.1A. Only use a USB
charger with suitable approval and certification. Do not charge in conditions outside
of the 10°C-45°C range.
4.
The USB Charging Cable features a red LED indicator light that will turn on when
Charging is complete or there is no battery connected. While it is charging the light
will be OFF.
5.
A full charge cycle will take approximately 90mins by 0.5A/1A/2.1A charger.
To charge the Transmitter:
1.
Connect the USB Charging Cable to the Remote Transmitter
2.
Connect the USB Charging Cable to an electronic device.
3.
Note: If using a wall charger, ensure that it is a certified product for your region. AC
Input: 100-240VAC 50/60Hz. DC Output: 5VDC 0.5A/1A/2.1A Only use a USB charger
with suitable approval and certification. Do not charge in conditions outside of the
10°C-45°C range.
4.
The USB Charging Cable features a red LED indicator light that will turn on when
Charging is complete or there is no battery connected. While it is charging the light
will be OFF.
5.
The Transmitter green LED indicator will be ON while it is charging. It will turn OFF
and the red LED indicator will switch on when complete.
Low Battery
The Drone LED Lights will flash when the drone is in Low Power Mode. When the LEDs are
flashing you should bring the Drone to a complete stop. Failure to note the Low Battery
signal may cause a sudden loss of power endangering Persons, Property and the Drone.
Running the Battery completely flat will impact the health and future flight time of your
Drone.