1.
TRANSPORT
The
circular knife sharpening machine RMS-NC
is delivered in a wooden box on
pallet.
The gross weight of the machine is 210 Kg.
The transport is done with the pallet by
a lifting cart or fork-lift truck.
1.1
ENVIRONMENTAL
CONDITIONS
FOR
SET
UP
4
Place and use the circular knife sharpening RMS-NC only in dry rooms.
Environmental temperature:
from +5 to +50°C
Humidity:
up to 90%; not condensing
1.2
SET
UP
Move the pallet as close as possible to the final position of the machine. Then remove the
screw joints between the machine and pallet. Before placing the machine at its final
position on the floor, screw in, the machine feet from below. Please pay attention that the
machine is aligned horizontal on the floor. The alignment should be done by use of a
bubble level (standard model is sufficient). Place the bubble level on top of the cabinet
and align in both direction by adjusting the machine feet.
Please pay attention, that the place of the machine grants a vibration free operation.
1.3
GENERAL
SAFETY
ADVICE
Read the operating manual intensive!
For damages caused by ignorance or not following the operating manual, no liability is
assumed!
When dealing with circular and shape knife greatest caution is needed, because this can
have the sharpness of a razor and it can result in significant cuts if handled carelessly.
To largely avoid these, the use of cut protection gloves is strongly recommended.
1.4
DIRECTED
USE
The circular knife sharpening machine RMS-NC is exclusively intended for sharpening
circular blade in the range of Ø 100 mm to Ø 350 mm. The directed includes also reading
this operation manual, as well as keeping all containing directions of use - especially the
safety information.
For all personal- and material damages, arising by not intended use, not the
manufacturer, but the user of the RMS-NC is responsible!
