KiWi ClickDiscs
Assembly
1)
Install the appropriate
ClickDisc
into the cavity on
the top of the barrel. Be sure to
orient the tab of the
ClickDisc
into the notch of the barrel.
Push the
ClickDisc
into posi-
tion.
2)
Place the horizontal plate
over the barrel and reinsert the
axle. Make sure that the plastic
washer is on the axle.
3)
Push down on the knob of
the axle to compress the as-
sembly and to retract the spring
plunger fully. As you apply pres-
sure on the knob, use the set
screw wrench to tighten and se-
cure the axle in position. There
should be no discernable play
between the barrel and plate.
4)
You may find it easier under
certain circumstances to
unscrew and retract the spring
plunger just a bit. It will be
easier to compress the assembly
this way. Be sure to readjust the
plunger afterwards.
How to install and remove ClickDisc indexing discs
4
Barrel w/ClickDisc Installed
Set Screw Wrench in Barrel
Axle w/Plastic
Washer
Horizontal Plate
Barrel
ClickDisc
Set Screw Wrench