KAI YIN KYZ2-2, User Manual, Page: 8 / 13

notice
Flight Mode and Warning
Flight Mode
Flight modes and warnings must comply with the following in order to avoid possible
injuries and losses:
You must be familiar with the characteristics of the aircraft and various flight modes
before switching from mode 1 to mode 2 or mode 3.
1) The D R channel of the remote controller sets the output of the control rudder, the small D
control is suitable for novice flight, and the large R control is suitable for skilled players. The 6-
channel switch sets the return position and unlock motor, the 1-mode :lock motor + turn off light,
the 2-mode: unlock motor + set return po turn on light ,the 3- mode: unlock motor + set
return po turn on buzzer alarm + light flashing.
The flight mode setting method of 5-channel switch is as follows.
No GPS manual flight mode setting
The use method of no GPS manual flight mode requires that the 6-channel unlocking switch is in
the 1 position, then the throttle is pulled to the lowest position, and then the 5-channel mode
switch is turned to the 1 mode. When the 6-channel unlocking switch is in the 2 position, the
motor will start to operate after unlocking. At this time, the throttle can be increased to fly in no
GPS manual mode. The flight mode can be switched after unlocking, and the 1-mode for flight
in normal manual semi-automatic mode, 2-mode for fixed altitude flight assisted by barometer,
3-mode for emergency landing with one key at current position. Attention! The 3-mode is not
recommended because the aircraft will land rapidly at the current position.
GPS flight mode setting
The GPS flight mode needs to be unlocked after satellite signal is found in outdoor flight. This
mode has one key take-off function. Therefore, it is not necessary to pull the throttle to the
lowest position. It is required that the 6-channel unlocking switch is in the 1 position. Then the
5-channel mode switch is moved to the 2-position. GPS signal searched, the blue lid light in
front will stop flashing and become normally on after signal is found. At this time, move 6- -
channel unlocking switch to 2-position to unlock. Attention! After unlocking, the aircraft will
automatically climb to the 2-meter-high position for fixed altitude hover and wait for your
control command. After unlocking, The flight mode can be switched, 1-mode for normal manual
semi self stabilization flight, 2-mode for full self stabilization fixed altitude flight with precise
hover assisted by barometer GPS positioning system , 3-mode for one key return to set position
and automatic landing with the help of GPS, compass, barometer. The return height is 10 meters
above the set return position. If there are tall buildings on the return route, it will affect the
return safety of the aircraft. Therefore, before using the return function, judge whether it can
avoid obstacles, and cancel the return if necessary.
2) Ensure that the key return function is used only in critical situations, because the return
function is affected by weather, environment and geomagnetic factors.
7
warning
!