Register / Pair Wireless RF Sensors:
All wireless door/window sensors & motion detectors must be properly registered (paired) at the controller.
·
Detach HSRS controller lid by removing the 4 retaining screws.
·
Locate the “Register” button.
·
Press/hold the button until the unit beeps, then release.
·
Activate a sensor. (For a door/window sensor, bring the magnet in close proximity to the transmitter
and then separate them. For a motion detector, walk in front of the sensor.)
·
Confirm that a red LED illuminates at the controller with an accompanied audible beep.
·
Repeat the previous two steps for each additional wireless sensor device (up to 8 max).
·
To exit wireless registration, press/release the register button. (There is no need to hold the button at
this step.)
Warranty
:
This product is warranted for a period of 1 year from the date of purchase and is guaranteed to be free from
defects. The warranty covers the entire unit, except if any part or component has been modified or otherwise
converted from its original form. The warranty does not cover damage or failure due to neglect, improper
setup/use, or unshielded exposure to moisture, power surges, hazardous environments, and the like.
Note: The customer is responsible to provide protection against over-voltage situations including power
surges, spikes, and lightning strikes. The use of adequate surge protection is recommended.
Disclaimer
:
The customer is responsible to obtain qualified assistance for proper installation of the product. We bear no
responsibility for unintended errors, omissions, or ambiguities in product literature. Further, we accept no
liability for unforeseen expenses, damages, personal injury, accident, or death due to use or misuse of the
product. Purchase and use of this product indicates that you understand and accept these terms.
Notes
:
7 of 7
