4
| Kaden
Wired Controller Manual
2. Installation Accessories
Select the installation location
Don’t install in areas that contain oil, vapor or sulfureted gas, otherwise, this product can deform which could permanently damage
the product.
1. Please confirm that you have all the following parts.
No.
Name
Qty.
Remarks
1
Wired controller
1
2
Wired controller manual
1
Kaden Wired Controller Manual |
1
Wired
Controller
Manual
DUCTED AIR CONDITIONER
KD24 | KD36 | KD42 | KD48 | KD60
KD Series
3
Screws
3
M4X20 (for mounting on the wall)
4
Wall plugs
3
For mounting on the wall
5
Screws
2
M4X25 (for mounting on switch box)
6
Plastic screw bars
2
For fixing on switch box
7
The connective wires group-1
1
Optional
8
The connective wires group-2
1
Connect to mainboard
9
Battery
1
2. Prepare the following assemblies on the site.
No.
Name
Qty. (embedded into wall)
1
Switch box
1
2
Wiring tube (insulating sleeve and tightening screw)
1
Preparation before installation
1. This manual explains the installation requirements for the wired controller. Please refer to the wiring diagram of this installation
manual to wire the wired controller to the indoor unit.
2. The wired controller operates in a low voltage loop circuit. Do not directly contact the cable of 220V commercial electricity or
of 380V high voltage, and don’t wire this kind of wire in the loop; wiring clearance between configured tubes should be at the
range of 300~500 or above.
3. The shielded wire of the wired controller must be grounded reliably.
4. Upon completing the wired controller connection, do not use a mega to detect the insulation.
5. The connective cable of the wired controller should not be longer than 20 meters.
Precautions
