4
OPERATING YOUR WINE CHILLER
These Wine Cooler should be placed in where the ambient temperature is between 5-35
℃
. If the ambient
temperature is above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The
range may not be reached.
The controls of your Wine Chilller
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
To control the appliance turn on/off.
To control the inner light turn on/off.
Used to set temperature in upper zone.
Used to set temperature in lower zone.
ON/OFF Power and memory function
To turn the Wine chiller ON or OFF, press and hold the power button for 2 seconds. The LED readout
will show the last set temperature.
Setting the Temperature Control
The Wine Cooler has two temperature zones.
Upper zone – temperature range 5
℃
to 12
℃
Lower zone – temperature range 12
℃
to 18
℃
You can set the required temperature either zone by pushing the
Set Upper
or
Set Lower
button.
When you push the two buttons for the first time, the LED readout will show the previously set
temperature set for that zones .
The temperature preset at the factory are
:
Upper zone
:
:
6
℃
Lower zone:
12
℃
To set the temperature in the Upper zone press
Set Upper
button once. The present temperature will
flash. The temperature will decrease by every time the button is pressed until minimum temperature is
reached, at which point it will then revert back to its maximum setting and start again.
To set the temperature in the Lower zone press the
Set Lower
button and follow the instructions
above.
To view the temperature set in either zone at any time, press the corresponding “
Set Upper
” or “
Set
Lower
” button, the “
Set
” temperature will temporarily flash in the LED display for 5 seconds.
Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent
bottles from falling.
