9
To control the inner light turn on/off.
Used to set temperature in upper zone.
Used to set temperature in lower zone.
Setting the Temperature Control
The Wine Cooler has two temperature zones.
Upper zone
– temperature range 5
to 12
Lower zone
– temperature range 12
to 18
You can set the required temperature either zone by pushing the Set Upper or Set Lower button. When
you push the two buttons for the first time, the LED readout will show the previously set temperature set
for that zones.
To set the temperature in the Upper zone press
Set Upper
button once. The present temperature will flash.
The temperature will decrease by every time the button is pressed until minimum temperature is reached,
at which point it will then revert back to its maximum setting and start again.
To set the temperature in the Lower zone press the
Set Lower
button and follow the instructions above.
To view the temperature set in either zone at any time, press the corresponding
“
Set Upper
” or “
Set Lower
”
button the
“
Set
” temperature will temporarily flash in the LED display for 5
seconds.
For
＆
KA110WR
＆
KSJ168EW
The temperature setting can be adjusted from 5
℃
to 18
℃
.
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
LIGHT
To control the inner light turn on/off.
In order to reduce energy consumption, this wine chiller will automatically switch off the LED lights after 10
minutes. If you want the LED light to remain on continuously, this is possible. Please press and hold the
"LIGHT" button for 5 seconds, the display will show "LP". After 4 seconds, the display will revert back to
normal and the light will remain on until manually switched off.
If you want to revert back and conserve energy (recommended), please press and hold the "LIGHT" button
for 5 second, the display will show "LF". After 4 seconds, the display will revert back to normal, and the light
will automatically switch off after 10 minutes KA39WR has no this function.
POWER
To control this
appliance turn on/off (press and hold this buttons for approximately 3 seconds).
“UP” Button
Used to raise (warm) the temperature in 1
℃
.
“DOWN” Button
Used to lower (cool) the temperature in 1
℃
.
“DISPLAY”
To shows the temperature of the internal chiller.
“TEMP.SET”
