Page 33
KACO blueplanet 3.0 NX3 M2 KACO blueplanet 5.0 NX3 M2 KACO blueplanet 8.0 NX3 M2 KACO blueplanet 10.0 NX3 M2
KACO blueplanet 15.0 NX3 M2 KACO blueplanet 20.0 NX3 M2
9.7.2
Dynamic feed-in
<Communication unit> menu opened.
The connection shown in the block
diagram Fig. 58 has been established.
Note:
For more information, see Chapter 9.15
on page 54.
1. Open the <Feed-in and meter settings>
menu.
2. Select meter model >> SDM630.
- Observe the note in Fig. 57!
3. Switch on <Enable meter data
processing> when the meter is connected.
4. Switch on <Enable feed-in control>
when the meter is connected.
5. At <Maximum feed-in power>, set the
maximum power which the device may
feed into the grid.
Note:
This setting is only possible under
2
conditions:
1.
Meter model connected to the device.
2.
<Active power regulation> is enabled
in the <Settings for> menu under
<Enable/disable functions>.
6. Start the function with <Confirm>.
5. Please remedy if these conditions are
not met. See Chapter 9.12 on page 42
»
Dynamic feed-in is selected.
Note
: select correct type:
- SDM630DC - RS485 + Modbus RTU
- SDM630CT – user-programmable
with RS485 + S0 output
Fig. 56.
Select feed-in and meter
settings
Fig. 57.
Select smart meter model
and set max. feed-in power
Fig. 58.
Block diagram for dynamic feed-in
