KACO blueplanet 3.0 NX1 M2 KACO blueplanet 3.7 NX1 M2 KACO blueplanet 4.0 NX1 M2
KACO blueplanet 5.0 NX1 M2
Page 4
Lifting and installing the device
Wall bracket mounted.
1 Lift the device using the recesses. Observe the centre of gravity!
2 Place the device onto the wall bracket.
Check both sides of the wall bracket to make sure that the device is firmly mounted.
3 Insert the provided screw into the wall bracket and fasten the device to secure against displacement.
[ P / 2 Nm]
NOTE: Alternatively: At this point, the screw described above can be replaced by a special screw as anti-theft protection.
»
Device is installed. Proceed with the electrical installation.
Fig. 6: Hang the inverter on the wall bracket
Fig. 7: Check the device is fix
Fig. 8:
Fixing the inverter
1.6
Making the electrical connection
NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic
conditions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
1.6.1
Configure AC connection
You have completed assembly.
1 Slide the cable fitting
and
housing and seal over the cable.
2 Remove the insulation from the cable. [sl. 53 mm]
3 Shorten N and L by 2 mm more than the protective earth
and
strip N, L, PE by 13 mm.
4 Flexible wires must be fitted with wire sleeves in accordance with DIN 46228.
5 Insert wires into the contacts in accordance with the markings on the contact carrier.
6 Tighten screws on contact carrier. [ T_8 / 2.0 Nm]
7 Press contact carriers into the housing with an audible "click".
8 Fix the housing and tighten the cable screw fitting [ W_29 / 3.5 Nm]
»
Make the electrical connections.