Kaco blueplanet 29.0 TL3 M1 OD II4S, Manual

Page: 19 / 91

6.4 Installing and securing the device
CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
› Always lift the device vertically using the openings provided.
› Use a climbing aid for the chosen installation height.
› Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation
mode due to insufficient ventilation and the resulting heat build-up.
› Observe minimum clearances and provide for sufficient heat dissipation.
› All objects on the device housing must be removed during operation.
› Ensure that no foreign bodies prevent heat dissipation following device installation.
1
2
4
3
Fig. 14: Lift the device using the opening
NO
5
4
Fig. 15: Insertion aid in mount
Key
1 Opening 4 Marking for insertion into mount
2 Centre of gravity 5 Outer contour of the mount
3 Warning sign (attachment prohibited)
Lifting and installing the device
↻ The mount has been installed.
1 Lift the device using the side recesses. Observe the device's centre of gravity!
NOTE: Do not lift the device by the lid or cover!
2 Suspend the device in the mount using the recess on the rear of the device. ( [See figure 13] [
}
Page 18]).
NOTE: Keep in mind that the lower marking on the housing must protrude over the upper outer contour of the
mount. Ensure that the upper marking is flush with the upper edge of the outer contour when lowering the device.
The outer contour of the mount must be flush with the outer contour of the housing.
3 Insert the screw provided into the lug of the mount and secure the device to prevent it from being lifted off [ T30 /
2 Nm]. ( [See figure 12] [ } Page 18]).
NOTE: Alternatively: At this point, the screw described above can be replaced by a special screw as anti-theft pro-
tection.
Kaco blueplanet 29.0TL3
Page 19
EN