9
Configuration and operation
9.1
Initial start-up
NOTE
The DC power supply must be guaranteed during initial start-up.
The sequence of the settings required for initial start-up is preset in the configuration assistant.
9.2
Control elements
The 3 LEDs on the device show the different operating states. The LEDs can display the following states:
LED illuminated
LED flashing
LED not illuminated
Operating status
LED
Icon
Description
Start
The green "
Operating
" LED is illuminated when AC and DC voltage is
present.
If the LED is flashing, the internal communication between the compo-
nents is established. After flashing, the device is ready for feed-in.
If the LED continues to flash permanently, the internal communication is
interrupted.
Feed-in start
The green "
Operating
" LED is lit.
The green "
Feed-in
" LED is illuminated after the country-specific wait-
ing period*.
The device feeds into the grid.
The interface switch engages audibly.
Non-grid feed mode
The green "
Operating
" LED is lit.
Error
No LED is lit.
Error on the device or AC/DC source
Error
The red "
Fault
" LED is lit.
Error on AC/DC source
Conditional special cases:
There is no DC voltage present (e.g. DC isolator switch open)
DC voltage too low (< starting voltage)
DC voltage is present (> starting voltage), but communications con-
nection between the front end (operating unit) and back end (control
unit) is faulty, or interrupted.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
Page 43
EN-US
