har
dw
ar
e k
ey
E
m4 8mm
screws
D
bin frame
p.
4
Ver. 2
W-50531
st
ep 2
attaching door panel
11.
9.
10.
2 x 31L
side mount pullout bin
Slide the back plastic catches of the bin lid along the
top of the lid brackets until both plastic catches fall into
the channels at the back. The front two plastic catches
should fit into the front channels at the same time.
Place the bin frame (D) carefully onto the extended runners,
aligning the holes and then securing into place with the 4 x M4
8mm screws (E).
Note:
Support the runners from underneath
when screwing the frame into place. Do not tighten screws.
E
D
inserting bin lid
attaching bin frame
The door can be adjusted
vertically by turning screw on
bottom of bracket up or down.
The depth of the door can be
adjusted by loosening off middle
screw and adjusting top/bottom
screws and then re-tightening
middle screw.
The door can be
adjusted horizontally by
loosening the screws in
the elongated slots and
moving door sideways.
Note:
Loosen off screws highlighted above before making
any adjustments to the door. Once adjustments are completed,
these screws must be tightened again.