Kabola Ecoline series, User Manual

Page: 11 / 32

Instruction manual Kabola KB-Series version 6, 2018
11
Figure 3
Figure 4
HORIZONTAL FLUE GAS OUTLET
It is possible to fit a horizontal flue gas outlet to the
boiler. The following points need to be observed:
 Make sure that the outlet is positioned at a sufficient
height above the waterline. If this is not possible use
a swan neck bend in the pipe as in figure 3.
 Use the correct hull fittings for installing the flue
through a hull side
 The maximum allowed length, without curves is 10
meters.
At more than 10 meters in length, always contact Kabola for advice.
 Don’t use more than 4 elbows of 90°.
 Every elbow of 90° is equivalent to 1 meter straight pipe
VERTICAL FLUE GAS OUTLET
This way if installation is preferable for seagoing boats and
sailing boats, because these boats encounter large angles of
heel through waves and under sail. For this kind of flue gas
outlet, the following points are important:
 Install a proper storm cowl on top of the chimney (this must
stop rain from entering) (figure 4).
 Install deck fittings for installing the flue through a deck.
 Install a water trap, to drain possible water caused by
condensation
 Keep the chimney as vertical as possible.
 Don't use more than 4 elbows 90°.
 The maximum allowed length is 10 meters. At more than
10 meters in length, always contact Kabola for advice.
 Every elbow of 90° is equivalent to 1 meter straight pipe.
 Use outside double walled chimney pipe
Hint:
To reduce the noise from flames, it
is wise to install a silencer in the
exhaust.
Figure 4.a
Your Kabola supplier can provide you with all components which may be required for installation such
as:
 Cowls;
 Flexible piping;
 Single and double walled chimney pipes;
 Hull and deck fittings;
Always install a drain with tap directly on the boiler
See Figure 4.a