Translation of the original operating manual for the KTS SpeedTec mini
B|HM0SM|00001|V0006|EN
Page
16
1. Touch panel
All machine programs are edited, saved and brought up at the touch panel. In addition,
machine settings can be made there.
2. USB port
This port can be used to connect a USB storage device.
3. On switch
Used to switch on the taping machine. When pressed, the hood is automatically locked.
4. Ready indicator
- Operational readiness is indicated by a flashing signal lamp.
-
The “On” operating state is indicated by a lit signal lamp.
5. Off switch
This switch can be used to deactivate the system. While the system is in a deactivated state,
the safety door can be opened.
6. Stop button
Press the stop button to stop the taping process.
7. Reset button / Fault indicator
The fault indicator lights up whenever a fault occurs. After being rectified, an active fault can
be cleared by pressing the “Reset” button.
8. Emergency stop button
Pressing the emergency stop button causes the taping machine to be stopped and switched
off immediately.
9.
“Edit” switch
Set-
up mode is activated via the “Edit” switch. Programs can be changed, deleted or copied,
and machine settings made, only with an active “Edit” switch setting.
10. Protective hood
The protective hood is automatically locked when the machine is switched on and serves to
protect the operator from moving parts during machine operation.
11. Line clamp on left side
The line connectors of the items for taping are inserted in the line clamp. The line clamp is
also used to clamp the lines.
12. Taping unit
The taping unit is used to wind adhesive tape around the items for taping.
13. Line clamp on right side
