Stand 15.02.2016
Seite 2 von 10
Mounting Instructions
82132/33 Code-Combi B with Plastic Control Unit
Any variation of the lock or key may result in functional trouble and must better not be done. All claims under guarantee
and warranty will expire in this case.
Lock fastening: Use of M6 steel socket head cap screws or BSW ¼" steel bolts. The length of engagement must
correspond to the applicable standards considering the thickness of the lock of 30 mm and the screwing height of the lock
case of 24 mm.
Fastening screws: minimum property class 4.8 and maximum property class 8.8.
Screws to be secured either by lock washer, flat spring, tooth lock washer, fan type lock washer considering the diameter
(d1) or to be cemented
Screw tightening moment: minimum 5 Nm and maximum 6 Nm.
The bolt must be floating in installed condition.
Perfect function of the lock and of any additional connected or triggered systems (e.g. boltworks) must be warranted and
checked by specialists during installation of the lock.
The lock must be mounted in closed condition (bolt extended).
The opening (cable gland) in the door of the secure storage unit may not be greater than 100 sq. mm (see mounting
drawings on Page 5 and following).
The lock is designed for installation in secure storage units made of steel. Installation in storage units consisting of other
material e.g. plastic is not allowed.
Do not apply any kind of force (e.g. hammer blows) for screw fitting and adjustment of the lock.
Lock to be installed covered and so as to prevent opening by boring.
The two way key must be insertable without jamming.
It is recommended, that unauthorized persons have no access to security sensitive parts of the lock, also the door of the
safe, where the lock is installed, is open.
Use of the Kaba Mauer key guide (see Fig. 1) is recommended. Considering DIN 2768-mH, the keyhole in the door of the
secure storage unit should be dimensioned accordingly (see Fig. 1).
Fig. 1: Key Guide 86101
In cases where the Kaba Mauer key guide or key carrier guide are not used, the maximum cross sectional area of the
keyhole in the door of the secure storage unit and/or the lock armour plating may not exceed the dimensions given in Fig. 2
considering DIN 2768-mH. All dimensions deviating from these specifications are to be coordinated separately with the
certification bodies (test houses).
Fig. 2: Maximum cross sectional area of keyhole
Code-Combi B
X (mm)
Y (mm)
71161
17
12.5
7,
5
m
ax
.
O
12
ma
x.
max. X
max. Y
R
4
R4
O
8
4,
2
4,
2
5,
9
5,
9
25,5
12,75
