kas.com.au
12
Verison: UG_V002
9
Passage Mode Function
Passage mode will leave the door in an “unlocked” state until mode is
deactivated. Passage mode allows access through the door without the
need for a pin code, key card/FOB or remote.
NOTE: If the lock is left in Passage Mode for a long period of time it will
signifcantly decrease battery life.
9.1
Activate/ Deactivate Passage Mode
a. Log into “Settings Management” [5.3]
b. Press “ 8 ", then press " * "
c. 6 Beeps -Identifies Passive Mode, 2 Beeps- Normal Status
10
Unlocking/ Locking Operation
From inside your door, your lock is always in an “unlocked” state, simply
rotate the handle down. From the outside, you will need to use one of the
following methods (unless in passage mode [9.0])
To lock your door, simply, push your door closed, the lock is
always in a ”locked” state from the outside. (Unless in passage mode
[9.0])
10.1
Using Pin Code To Open The Lock
a. Power on by touching the screen- blue lights on keypad screen indicates
power is on
b. Enter pin code, then press " * "
c. A beep will sound, motor engages. Now rotate handle to open the lock
10.2
Using Key Card/FOB To Open The Lock
a. Swipe any programmed Key card/FOB over the keypad
b. A beep will sound, motor engages. Now rotate handle to open the lock
10.3
Using Remote Control To Open The Lock
Remote controls can be used from up to 20 meters away without direct
view.
a. At any stage, press the remote controller
b. A beep will sound, motor engages. Now rotate handle to open the lock
