5. Install the Defuser module(s) to
the desired mounting surface
using the included 3/4” screws
or nylon mounting nuts and
bolts.
6. For proper performance, the
Defuser EX and EX2 must be
mounted completely level. A
unit which is positioned up,
down, or to the side by as little
as 1° can reduce jamming effec-
tiveness by as much as several
hundred feet (see diagram B4).
Be sure that the vehicle is on a
level surface before checking
installation.
JAMMING BEAM
Enlarged
View
JAMMING BEAM
LASER DEFUSER
Enlarged
View
NO
CORRECT
LASER DEFUSER
DIAGRAM B4
Enlarged
View
NO
JAMMING BEAM
LASER DEFUSER(S)
Enlarged
View
CORRECT
JAMMING BEAM
LASER DEFUSER EX & EX2
(REAR LICENSE PLATE MOUNT WITHOUT FRAME)
1. Remove the mounting bolts and any existing frame or cover from the rear license plate. Remove license plate.
2. Remove the three unused horizontal mounting tabs from the top of the supplied universal mounting bracket.
3. Apply the supplied double stick tape directly to the Defuser module and attach it to the mounting bracket with
the included 1/4” screws. Position the Defuser module against the license plate and mount it to the factory
license plate bracket using the existing mounting bolts or K40 supplied nylon bolts (see diagram C1)
To assure the Defuser module(s) is/are properly leveled, insert the rod
on the K40 supplied level into the leveling assembly hole located near
the middle of the Defuser module(s)(see diagram B5).
7. Route the black cable(s) into the engine compartment, either through
the grill or under the bumper. Connect the Defuser EX or EX2 wires
per the separate enclosed block diagram sheet.
DIAGRAM B5
If using an EX system, first separate the module from the license plate frame by removing the
two screws on the backside of the frame.
NOTE:
DIAGRAM C1
40
JAMMING BEAM
JAMMING BEAM
LASER DEFUSER(S)
