PHD6 Quick Reference Card
Operation
Procedure
Turn on
Press MODE button.
Turn off
Hold MODE button until display says “release.”
Auto Cal
Turn PHD6 on and allow sensors to stabilize. Take
to fresh air. Press MODE 3 times to enter “Auto Cal
Mode.” At prompt press MODE to Auto-Zero. At
next prompt press MODE to begin Auto-Span.
Attach calibration adaptor and fittings. Apply span
gas. Remove fittings when complete. If Auto-Zero
or Auto-Span fails see Reference Manual.
01JUNE2011 – Rev. 2.00 – 13-323.doc
