Warning LED(s)
1. Consult with vehicle owner about LED location. For best visibility, choose a
mounting location as close to the vehicle gauges as possible.
2. Check for proper clearance behind the area where the LED(s) will be
installed (approximately 1”) and drill a 3/16” hole in the chosen location
for the LED(s). CALIBRE
DL
models require the mounting of a second
LED for rear radar warnings.
3. Route all of the LED wires under the dash per DIAGRAM A1.
FRONT
ALERT
REAR
ALERT
GREY LED WIRE
GREY LED WIRE
Unlike other radar detectors and aftermarket accessories, the K40 Calibre will not interfere with the vehicle's
complex electronic systems. The K40 Calibre has its own independent Bluetooth
®
network with its own
unique address.
Inst
Inst
all
all
a
a
ti
ti
o
o
n
n
Instr
Instr
uc
uc
ti
ti
o
o
ns
ns
& R e c o m m e n d e d
P r o c e d u r e s
DIAGRAM A1
Warning Pod(s)
1. Consult with vehicle owner about Pod location. For best visibility, choose a
mounting location as close to the vehicle gauges as possible.
2. Before mounting the Warning Pod(s), clean both the Pod surface and
desired mounting location on the dash with rubbing alcohol.
3. Position the Warning Pod(s) on the dash with the provided double stick
“O” ring tape. CALIBRE
DL-P
models require the mounting of a second
Pod for rear radar warnings.
4. Route the black cable(s) from the Warning Pod(s) through or under the
dash per DIAGRAM B1.
DIAGRAM B1
FRONT
WARNING POD
REAR
WARNING POD
WHITE
GREY
BLUE
GREY
1. Remove the under dash
panel and mount the Interior
Network Module using the
supplied cable ties to the
existing factory wire looms,
brackets, or other support
structures as per DIAGRAM
C1. The Interior Network
Module can be mounted hor-
izontally or vertically under
the dash.
2. Connect the LED, ignition-on,
and ground wires per the
separate enclosed block
diagram sheet.
HORIZONTAL MOUNT
VERTICAL MOUNT
INTERIOR NETWORK
MODULE
WIRE TIE
WIRE TIES
WIRE TIE
DIAGRAM C1
INTERIOR NETWORK
MODULE
Interior Network Module
WHITE LED
WIRE
BLUE LED
WIRE
“O” RING
TAPE
“O” RING
TAPE
NOTE: