K40 1000, Installation Instructions

Page: 3 / 4

REAR RADAR RECEIVER
(MODELS: K40-2000/2000P)
1. Choose a mounting location in the rear of the vehicle that is not
obstructed by any metal, carbon fiber, or chromed plastic. The
radar receiver can be mounted horizontally or vertically, provided
the arrows are pointing to the rear, towards the road behind the
vehicle.
2. Mount the radar receiver to the vehicle's structure using the sup-
plied screws or wire tires (see diagram E1).
3. Connect the radar receiver to the 25’ black radar receiver cable.
Align slot on cable plug to the notch on radar receiver socket, slide
the locking ring forward over the socket, and turn ring clockwise
1/4 turn to engage safety lock (see diagram E2).
4. Route the rear radar receiver cable into the trunk through a
factory grommet.
5. If a factory grommet is not available, use the provided strain relief:
a. Choose a location in the trunk compartment as close to the
radar receiver as possible.
b. Drill a 1/2” hole into the chosen location for the strain relief.
c. Install the strain relief and tighten the mounting nut securely
(see diagram E3)
d. Route the rear radar receiver cable through the strain relief,
leaving a little slack in the receiver cable.
e. Tighten the waterproof gasket nut to create a water proof seal.
6. Route the rear radar receiver cable through the trunk, into the
passenger compartment along the driver's side, and under the
dash. Connect wires according separately enclosed block
wiring diagram.
All radar receivers can be mounted behind plastic, rubber, or fiberglass up to 1/4” thick. Do not mount
behind metal, carbon fiber, or chromed plastic.
NOTE:
METAL
SUPPORT
SCREWS
REAR RADAR RECEIVER
(BEHIND BUMPER COVER)
RECEIVER
DIAGRAM E1
DIAGRAM E2
VOLUME CONTROL MODULE
(all MODELS)
1. Choose a mounting location that's accessible to the driver in the dashboard area
or in the vehicle's center console that will not obstruct or block any moving parts.
Before drilling, make sure there is enough clearance for the
Volume Control Module behind the chosen mounting location
(approximately 3 1/4”).
C AUTION!
2. Drill a 5/16” hole.
3. Mount the Volume Control Module with the lock washer and nuts, and push the
filter and volume adjustment knobs onto the module shaft (see diagram F1).
4. Route the Volume Control Module cable under the dash and connect wires
according to the separately enclosed block wiring diagram.
ON-OFF/
FILTER
ADJUSTMENT
VOLUME
CONTROL
MODULE
MOUNTING
NUTS
ON-OFF/FILTER
ADJUSTMENT
KNOB
LOCK
WASHER
VOLUME
CONTROL
KNOB
DIAGRAM F1
DIAGRAM E3
ROUTE THROUGH VEHICLE
MOUNTING NUT
METAL
TRUNK
WATERPROOF
GASKET MATERIAL
TO RADAR DETECTOR
Do not drill into the trunk until you know
what is on both sides of the drilling area.
Watch for cables, spare tires, and gas tank.
C AUTION!
LOCKING RIB
LOCKING
WINDOW
LOCKING
PIN
LOCKING
RING
KEY
GUIDE
KEY WAY
LOCKING
PIN