- 2 -
INSTALLING THE UNIT
Mounting Guidelines
For the best performance, select the proper location for the detector where it has
a direct view of the road. Remember the radar antenna and laser sensor are
located behind the rear panel of the unit.
The antenna and sensors should not be obstructed by metal or metallic surfaces
and should be pointed at the horizon for accurate long-range detection.
- Choose a location that does not block the driver's vision.
- Mount the detector in a level position.
- Do not mount the detector behind the metal surfaces and ornaments mirrored
sunscreen.
Tinted windows reduce the received laser signal strength.
Do not mount the detector behind tinted glass. Do not mount the detector where
the driver or passenger might hit in a sudden stop or accident.
Mounting Type
There are two ways of installation.
Hook and Loop Mounting
The hook and loop tape included with your detector might be the best mounting
method for some dashboards.
Follow these instructions to use the hook and loop tape to mount the unit on the
dashboard.
1.
Use a damp cloth to thoroughly clean the dashboard.
2.
Peel off the paper backing of the tape and apply the tape to the bottom of the
detector.
3.
Remove the paper backing from the other side of the tape and press the
detector onto the dashboard.
- 3 -
Windshield Mounting
The supplied windshield bracket and suction cups let you quickly mount the
detector on your vehicle’s windshield.
Follow these steps to use mounting bracket kit.
1.
Install the suction cups onto the bracket by fitting them into their holes.
2.
Attach the bracket to windshield.
3.
Attach the detector to the bracket.
4.
Bend bracket for correct detection angle.
5.
Plug power cord DC12V into detector.
6.
Plug power cord into cigarette lighter.
Cautions: Some new models of cars have a plastic safety coating which is
applied to the windshield. The suction cups may leave permanent marks on the
wind shield once they are removed. Check vehicle owner’s manual to see if your
car has the plastic safety coating.
Connecting the Power
The RD950 detector is designed to operate on most DC 12V negative ground
vehicle electrical systems. The power cord provided with the detector has a
cigarette lighter socket plug at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the detector.
2. Insert the other end into the cigarette lighter socket of your vehicle.
If the detector does not operate when you turn it on, remove the adapter from the
cigarette lighter socket and carefully check the socket for debris. Also, check the
fuse in the adapter and your vehicle's fuse box.
Replacing the Fuse
If the detector stops operating, the fuse in the cigarette lighter plug might be
blown. If it has blown, follow these steps to replace it:
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has blown. If it has, replace it.
